drivers/mtd/spi-nor/xilinx.c:93 [spi_nor]xilinx_nor_read_sr =_ "error %d reading SR\n"
drivers/mtd/spi-nor/winbond.c:174 [spi_nor]winbond_nor_write_ear =_ "error %d writing EAR\n"
drivers/mtd/spi-nor/sst.c:34 [spi_nor]sst26vf_nor_unlock =_ "Any block has been permanently locked\n"
drivers/mtd/spi-nor/sst.c:133 [spi_nor]sst_nor_write =_ "to 0x%08x, len %zd\n"
drivers/mtd/spi-nor/spansion.c:271 [spi_nor]cypress_nor_octal_dtr_dis =_ "error %d reading JEDEC ID after disabling 8D-8D-8D mode\n"
drivers/mtd/spi-nor/spansion.c:227 [spi_nor]cypress_nor_octal_dtr_en =_ "error %d reading JEDEC ID after enabling 8D-8D-8D mode\n"
drivers/mtd/spi-nor/spansion.c:96 [spi_nor]spansion_nor_clear_sr =_ "error %d clearing SR\n"
drivers/mtd/spi-nor/micron-st.c:113 [spi_nor]micron_st_nor_octal_dtr_dis =_ "error %d reading JEDEC ID after disabling 8D-8D-8D mode\n"
drivers/mtd/spi-nor/micron-st.c:77 [spi_nor]micron_st_nor_octal_dtr_en =_ "error %d reading JEDEC ID after enabling 8D-8D-8D mode\n"
drivers/mtd/spi-nor/micron-st.c:366 [spi_nor]micron_st_nor_clear_fsr =_ "error %d clearing FSR\n"
drivers/mtd/spi-nor/micron-st.c:341 [spi_nor]micron_st_nor_read_fsr =_ "error %d reading FSR\n"
drivers/mtd/spi-nor/atmel.c:92 [spi_nor]atmel_nor_set_global_protection =_ "unable to clear SRWD bit, WP# asserted?\n"
drivers/mtd/spi-nor/atmel.c:35 [spi_nor]at25fs_nor_unlock =_ "unable to clear BP bits, WP# asserted?\n"
drivers/mtd/spi-nor/swp.c:419 [spi_nor]spi_nor_try_unlock_all =_ "Failed to unlock the entire flash memory array\n"
drivers/mtd/spi-nor/swp.c:415 [spi_nor]spi_nor_try_unlock_all =_ "Unprotecting entire flash array\n"
drivers/mtd/spi-nor/sfdp.c:1197 [spi_nor]spi_nor_parse_profile1 =_ "Can't find dummy cycles from Profile 1.0 table\n"
drivers/mtd/spi-nor/sfdp.c:649 [spi_nor]spi_nor_parse_bfpt =_ "16-bit opcodes not supported\n"
drivers/mtd/spi-nor/sfdp.c:645 [spi_nor]spi_nor_parse_bfpt =_ "Reserved command extension used\n"
drivers/mtd/spi-nor/sfdp.c:624 [spi_nor]spi_nor_parse_bfpt =_ "BFPT: 4-Byte Address Mode method is not recognized or not implemented\n"
drivers/mtd/spi-nor/sfdp.c:612 [spi_nor]spi_nor_parse_bfpt =_ "BFPT QER reserved value used\n"
drivers/mtd/spi-nor/sfdp.c:1497 [spi_nor]spi_nor_parse_sfdp =_ "failed to read SFDP data\n"
drivers/mtd/spi-nor/sfdp.c:1469 [spi_nor]spi_nor_parse_sfdp =_ "SFDP data (%zu) too big, truncating\n"
drivers/mtd/spi-nor/sfdp.c:1448 [spi_nor]spi_nor_parse_sfdp =_ "failed to read SFDP parameter headers\n"
drivers/mtd/spi-nor/core.c:1993 [spi_nor]spi_nor_sr2_bit7_quad_enable =_ "SR2: Read back test failed\n"
drivers/mtd/spi-nor/core.c:1025 [spi_nor]spi_nor_write_sr2 =_ "error %d writing SR2\n"
drivers/mtd/spi-nor/core.c:1087 [spi_nor]spi_nor_erase_chip =_ "error %d erasing chip\n"
drivers/mtd/spi-nor/core.c:1072 [spi_nor]spi_nor_erase_chip =_ " %lldKiB\n"
drivers/mtd/spi-nor/core.c:1806 [spi_nor]spi_nor_erase =_ "at 0x%llx, len %lld\n"
drivers/mtd/spi-nor/core.c:920 [spi_nor]spi_nor_write_16bit_sr_and_check =_ "CR: read back test failed\n"
drivers/mtd/spi-nor/core.c:906 [spi_nor]spi_nor_write_16bit_sr_and_check =_ "SR: Read back test failed\n"
drivers/mtd/spi-nor/core.c:973 [spi_nor]spi_nor_write_16bit_cr_and_check =_ "CR: read back test failed\n"
drivers/mtd/spi-nor/core.c:961 [spi_nor]spi_nor_write_16bit_cr_and_check =_ "SR: Read back test failed\n"
drivers/mtd/spi-nor/core.c:780 [spi_nor]spi_nor_global_block_unlock =_ "error %d on Global Block Unlock\n"
drivers/mtd/spi-nor/core.c:538 [spi_nor]spi_nor_set_4byte_addr_mode_en4b_ex4b =_ "error %d setting 4-byte mode\n"
drivers/mtd/spi-nor/core.c:505 [spi_nor]spi_nor_read_cr =_ "error %d reading CR\n"
drivers/mtd/spi-nor/core.c:845 [spi_nor]spi_nor_write_sr1_and_check =_ "SR1: read back test failed\n"
drivers/mtd/spi-nor/core.c:815 [spi_nor]spi_nor_write_sr =_ "error %d writing SR\n"
drivers/mtd/spi-nor/core.c:2140 [spi_nor]spi_nor_write =_ "to 0x%08x, len %zd\n"
drivers/mtd/spi-nor/core.c:736 [spi_nor]spi_nor_wait_till_ready_with_timeout =_ "flash operation timed out\n"
drivers/mtd/spi-nor/core.c:475 [spi_nor]spi_nor_read_sr =_ "error %d reading SR\n"
drivers/mtd/spi-nor/core.c:3547 [spi_nor]spi_nor_scan =_ "mtd.eraseregions[%d] = { .offset = 0x%llx, .erasesize = 0x%.8x (%uKiB), .numblocks = %d }\n"
drivers/mtd/spi-nor/core.c:3539 [spi_nor]spi_nor_scan =_ "mtd .name = %s, .size = 0x%llx (%lldMiB), .erasesize = 0x%.8x (%uKiB) .numeraseregions = %d\n"
drivers/mtd/spi-nor/core.c:2720 [spi_nor]spi_nor_set_addr_nbytes =_ "The number of address bytes is too large: %u\n"
drivers/mtd/spi-nor/core.c:2682 [spi_nor]spi_nor_default_setup =_ "can't select erase settings supported by both the SPI controller and memory.\n"
drivers/mtd/spi-nor/core.c:2674 [spi_nor]spi_nor_default_setup =_ "can't select write settings supported by both the SPI controller and memory.\n"
drivers/mtd/spi-nor/core.c:2666 [spi_nor]spi_nor_default_setup =_ "can't select read settings supported by both the SPI controller and memory.\n"
drivers/mtd/spi-nor/core.c:2657 [spi_nor]spi_nor_default_setup =_ "SPI n-n-n protocols are not supported.\n"
drivers/mtd/spi-nor/core.c:2059 [spi_nor]spi_nor_detect =_ "error %d reading JEDEC ID\n"
drivers/mtd/spi-nor/core.c:405 [spi_nor]spi_nor_write_disable =_ "error %d on Write Disable\n"
drivers/mtd/spi-nor/core.c:378 [spi_nor]spi_nor_write_enable =_ "error %d on Write Enable\n"
drivers/mtd/spi-nor/core.c:2093 [spi_nor]spi_nor_read =_ "from 0x%08x, len %zd\n"
drivers/mtd/spi-nor/core.c:600 [spi_nor]spi_nor_set_4byte_addr_mode_brwr =_ "error %d setting 4-byte mode\n"
drivers/mtd/spi-nor/core.c:1057 [spi_nor]spi_nor_read_sr2 =_ "error %d reading SR2\n"
drivers/mtd/spi-nor/core.c:3190 [spi_nor]spi_nor_init =_ "quad mode not supported\n"
drivers/mtd/spi-nor/core.c:3184 [spi_nor]spi_nor_init =_ "octal mode not supported\n"